Toggle Maps - Event Queue

Feature Prerequisite'

This feature allows a user to toggle the display of the map on or off in the event queue window. To use this feature, the "Alarms/Maps/ToggleEventQueue" feature must be enabled. Enabling this feature is controlled by your SureView Systems Administrator and may be dependent on your individual license.  To enable the feature, go to your feature setup and locate the "ToggleEventQueue" feature. The image below shows where to enable this feature in your feature setup.

Usage

To hide the display of the map, click on the button with the chevron icon on the top right hand side of the map. This can be seen in the image below where the chevron icon is circled in red. This will slide the map to the right hiding its display.

The map then slides away and remains hidden. The image below shows the map in its hidden state.

To toggle the map' display back on, locate the button with the chevron icon on right side of the window on the border. This can be seen in the image below circled in red. This will slide the map back on to the page.

In the case when a user is clicks on the map marker icon against an event record. If the map is hidden, it will be re-displayed. The map marker icon is found under the "Actions" column of the event queue. This is shown below in the image and circled in red.

In the case when a user is required to carry out a manual raise, clicking on the "MANUAL RAISE" button will toggle the map' display back on if the map was hidden. This button can be found at the top of the window. The button is shown in the image below and is circled in red.